I was wondering if anyone had any pointers on how to begin a simple vibration analysis in PTC Simulate 3.0.
What I've done so far:
Modelled: A plate, attached to a mass using 4 bolts (in red) as shown in the simple diagram below.
Applied Loads: Applied 1g (where g is gravity) loads in X, Y, and Z directions
Preformed a Modal Analysis
What I would like to do:
I would now like to apply vibration loads in X, Y and Z directions to the model. I would then like to view the stresses and deformation in the plate as a result of these vibrations. How do I do this.
Baby steps would be much appreciated.