Cams with liftoff
Hi all,recently I made an assembly that required some cams with liftoff.The problem is that when I done a dynamic analysis, Mechanism needed a lot of time. So I made a simplified assembly where I...
View ArticleClik here to view.
Creo4.0 convergence plots
Does anyone know how to control what is displayed in the graph? I opened the run status again and the graph displayed Deflection vs load I couldn't get back to the norm vs iteration I couldn't see a...
View ArticleClik here to view.
Mechanism, spring graphics connected to wrong body.
Hello. I have recently started to use Creo Mechanism which is a bit finnicky and not user friendly but I think I am slowly getting the hang of it.I have set up a mechanism with a spring between two...
View ArticleClik here to view.
Creo Simulate "Lost network license" while running non-linear analysis with...
Hi, Has anyone else found while running a Non-Linear analysis with contacts that Creo Parametric Simulate loses the network license?The license server needs to be on a separate computer on the...
View ArticleClik here to view.
Material model question
Hello, I am using a hyperelastic material model. To check the simulation, I defined a monitor point to see the stress in the function of strain. I think, the defined matarial curve and the...
View ArticlePoint radiation condition warning
I'm running a structural analysis in Creo Simulate 3.0 and I receive the following warning: "This point has a radiation condition, but is not part of any element". I see this in the diagnostic viewer...
View ArticleClik here to view.
Non-symmetric results for symmetric model and load?
Why is it that displacement for a cone is not rotational symmetric for an internal pressure?A sample model is attached (Creo 3.0) I've brought it back to the bare minimum. 1/4 cone, symmetry, default...
View ArticleIs it possible to impose more thermal boundary conditions on the same surface?
Hello, I am new to CREO Simulate and I have just started to work on thermal simulations. I have a problem concerning boundary conditions for a steady state thermal analysis: in particular I cannot...
View ArticleClik here to view.
Design value for linearized stress results...?
Does anyone have any experience from standards like ASME or similar, etc where linearized stress results are used for dimensioning? I have no problem understanding the linearized stress query, but how...
View ArticleClik here to view.
Getting fasteners to work
So, inspired by Roland Jakel's presentation, I thought I'd revisit an old analysis and try to re-run it using the fastener functionality. Unfortunately, the analysis ran with "The fastener is invalid"...
View Article