OK I have a specific error that no one here at work has seen before. I have a large model running a modal analysis on, single pass adaptive, and after the second run sometime during or after the displacement and stress results are happening I am getting the error "The design study terminated abnormally" which generally doesn't bother me in the beginning of an analysis because that means something is wrong and I can fix it but that error at the end of the run throws me off a bit. Additionally I get a very specific internal error dialogue shown below...
*** A fatal error has occurred. ***
An internal error has occurred in file S:\sim\engine\src\common\post\resultsOut.cxx, line 96.
An internal engine error has occurred. Please be sure
to run error checking before you run this study. If
you have run error checking, then contact Customer Support.
Any clue what the error means? Also my diagnostics look good other than a warning about a beam element that doesn't have recovery points defined, would that cause this error? In that particular beam I am not worried about stresses.
Thanks in advance for any assistance on this one.