Hello,
I just noticed something that seems to be a bug of the software, If I am not wrong.
By chance, I carelessly created and run two structural static analyses with the same name but in two different output directories (otherwise, if in the same, it would not have been possible): one is in the default output directory and the other is another path (which I call here "B").
These two analyses were on the same assembly, however the difference between them (in addition to the different output folder as wrote before) was that the model differs in one component from one analysis to the other (one has a tube instead of a joint plate).
The problem is that when I try to open that result file in path B with the command "Results from template" (form Analyses and Design Studies window), the software goes to pick up the other one (which, as said, has the same name), which is located in the default directory --> so I see the joint plate instead of the tube as it should be.
Beyond the fact that, I know, it's not a good habit to use the same analysis name in two different models (the reason was that these were only draft tests, so didn't matter the name), could I fix someway this thing (in case it happens again) or is it a defect of the software??
thanks
Bye Bye