I am attempting to run a dynamic frequency analysis on a vertical bottle. I define everything, in that the modal and static give good results. I am a little hesitant on how exactly the DFA works (as far as what the inputs are, I've done this in other software), but that is not really the question here, as I am sure I can figure it out once I start seeing results.
After my DFA completes, I go to display results and the options available to me are very limited. It must be a graph and ordinate must be a measure (with abcissa freq/measure). The problem is, even though there are predefined measures, and I have defined measure that are compatible with DFA and DTA, there are ZERO measures available to choose from. Where are the measures? Searching for answers is difficult as I am always directed to rants about the measurement tool.
I also found that this was a problem, with apparently not solution in Wildfire?