Hi,
I'm running into issues trying to run a cyclic symmetry analysis on one part of a large disk - whenever I try to mesh the model, it returns the following error:
The requested shape change invalidates the Cyclic Symmetry
constraints associated with the highlighted geometry. Delete
these constraints if the requested shape change is required.
Source: AutoGEM
What shape change is this referring to, and why does that invalidate the constraint?
The model I'm working with is cut into pieces at a slight angle - so the faces selected for cyclic symmetry are not perpendicular to the 'front' face of the disk model. Would this cause an issue?
Thanks
Will